
|
| Typ |
Accessories
其他附件 |
KU
9608 |
Symmetrical Bypass switch EN 55015 / CISPR 15 |
| BD
9501 |
IEEE-488 Bus-Feed through for flange mounting (shielded
rooms) (other feed throughs on request) |
| HPF |
High Pass Filter 35 - 1000 MHz, Insertion loss at 27.12 MHz
typ. 100 dB |
| CVP
9222 |
High Impedance Capacitive Voltage Probe acc. to CISPR 22, EN
55022 C 1.3. Frequency range: 9 kHz – 100 MHz. |
| CVP 9222 Opt. ACS 110 |
Option: Charger ACS 110 for CVP 9222. |
| CVP 9222
Opt. KA |
Option: Calibration Adapter for CVP 9222. |
| SW
9602 |
Current Transformer, shielded, 0.01 - 200 MHz, Transfer
Impedance: 1 Ohm for wires up to 6.5 mm. |
| SW
9603 |
Current Transformer, shielded, 9 kHz - 150 MHz, Transfer
Impedance: 1 Ohm for wires up to 14 mm. |
| SW
9605 |
Current Transformer Clamp CISPR 22, 9 kHz - 80 MHz, Transfer
Impedance: 1 Ohm for wires up to 23 mm. |
| SY
9501 |
Balun unsymm. 50 Ohm to symm. 150 Ohm EN 55015, CISPR
15 [图片] |
| SY
9223 |
Broad band isolation transformer SY 9223 acc. CISPR 13 fig.
A.2, 50 Ohm 75 Ohm. |
| VTSD
9561 |
Limiter + 20 dB Attenuation, BNC |
| VTSD 9561
F |
Diode Pulse Limiter + 10 dB Attenuation, fuse lamp,
BNC |
| VTSD
9562 |
Bandpass and Limiter for Partial Discharge Measurements
BNC |
| BBV
9720 |
Broadband Coaxial Preamplifier 10 dB, 20 MHz – 1 GHz
N-male/female |
| EW 9721 |
DC-Separator for BBV 9720 |
| BBV 9740
DISCONTINUED |
Broadband Coaxial Preamplifier 20 dB, 9 kHz - 4 GHz with
power supply. Data for information only! The BBV 9740 has been replaced by
the BBV 9742. [图片] |
| BBV 9741
DISCONTINUED |
Broadband Coaxial Preamplifier with ESD protection. Gain 20
dB, 9 kHz – 1 (4) GHz with power supply. Data for information only! The
BBV 9741 has been replaced by the BBV 9742. |
| BBV
9742 |
Broadband Coaxial Preamplifier amplification max. 30 dB, 9
kHz – 4 GHz, low noise floor, ESD protected, N-jack N-plug, including
power supply. |
| BBV
9718 |
Broadband Coaxial Preamplifier typ. 33 dB, 1 - 18 GHz with
fixture for 22 mm |
| BBV 9718 Opt Akku |
Option: Rechargeable battery pack for BBV 9718 [图片] |
| BBV 9718 Opt. ALCS 2-24A |
Battery charger ALCS 2-24A for rechargeable battery
pack |
| BBV 9718 Opt. PS |
Option: Power supply for BBV 9718 |
| |
Coaxial Cables
同轴射频电缆 |
| AK
9513 |
50 Ohm Coax. Cable with N plugs, individual length, usable
up to 3 (5) GHz. Indiv. Cal. possible if cable longer than 3 m. Standard
lengths: 3 m, 5 m, 10 m. |
| AK 9515
D |
50 Ohm Coaxial Cable with N plugs, low loss, limited
flexibility, usable up to 10 (18) GHz, 10.5 mm diam. Indiv. Cal. possible
if cable longer than 1 m. |
| AK 9515
E |
50 Ohm Coaxial Cable with N plugs, low loss, good
flexibility, usable up to 10 (18) GHz, 10.8 mm diam. Indiv. Cal. possible
if cable longer than 1 m. |
| AK 9515 H |
50 Ohm Microwave Coaxial Cable with N-connectors, low loss,
flexible, usable up to 18 GHz. Indiv. Cal. possible if cable longer than 1
m. [图片] [参数1] [参数2] |
| |
Fixed Attenuators
固定衰减器 |
| DGA 9550
N |
10 dB fixed attenuation, 0 – 1000 MHz, N – connectors male /
female |
| DGA 9560
B |
10 dB fixed attenuation, 0 – 1000 MHz, BNC male /
female |
| |
Reference Radiators
参考辐射源 |
| SG
9301 |
Spectrum Generator 30-1000 MHz, spectrum lines switchable
100 Hz – 1 MHz, N-female connector, charger 230 V AC, main application:
reference radiator (antenna required e.g. UBAA 9114 with BBVU
9135) |
| SG
9302 |
Comb generator 0.1 – 18 GHz, spectrum lines every 100 MHz,
battery driven, including charger. |
| |
Field meters
场强计 |
| IEMH 1601 |
Isotropic hand held electric field meter 1.8 – 30 MHz, 0.05
… 500 V/m |
| EHMG
1623 |
Analogous Display unit for FMZB series |
| EHAG
1624 |
LCD-Display Unit for EFS 9218, 9219, HFS 1546, FMZB
series |
| VUFM
1670 |
E-Field Meter 70 kHz-2.5 GHz, 1V/m-300V/m, linear
polarized |
| VUFM
1671 |
LCD-Display Unit for VUFM 1670 with 5 m fibre optical
link |
| VUFM
1672 |
LCD–Display Unit VUFM 1672 for E - Field-Meter VUFM 1670
with optical link and IEEE 488 / GPIB – Interface. |